Skip to content

P2162 – Vehicle Speed Sensor A/B Correlation (OBD2)

P2162 means "Vehicle Speed Sensor A/B Correlation". Two signals that should agree with each other no longer match. The control unit cannot tell which one is wrong, so it stores a correlation fault for the vehicle speed sensor.

Last updated

P2162 quick summary

Fault codeP2162
MeaningVehicle Speed Sensor A/B Correlation
SystemPowertrain (Engine & Transmission)
VehiclesGeneric OBD2
SeverityMedium
Can I drive?Yes, carefully. The speedometer may be wrong or dead and the automatic gearbox may shift harshly – keep an eye on your speed.
Repair cost€30 – €400

How vehicle speed is measured

The vehicle speed signal is used by the speedometer, gearbox, cruise control, power steering and engine management; these codes mean the signal is missing, implausible or the control unit's speed output has a fault.

Older cars have a vehicle speed sensor on the gearbox output shaft. Most modern cars calculate speed from the ABS wheel speed sensors and share it over the CAN bus. The engine control unit uses vehicle speed for idle control, fuel cut-off, cruise control and to detect whether the car is moving.

Codes P0500–P0503 report a missing, implausible or erratic speed signal; P0608 and P0609 report faults in the control unit's speed output to other modules. If the signal is lost, cruise control stops working, automatic gearboxes may shift badly or go into limp mode and the speedometer may stop.

Causes include a failed sensor, a damaged reluctor ring, wiring problems and – on cars that use ABS data – an ABS sensor or ABS module fault.

Symptoms of P2162

  • Speedometer not working or jumping
  • Cruise control not working
  • Harsh or wrong gear changes (automatic gearbox)
  • ABS or traction control lights on (if ABS sensors are involved)
  • Check Engine light on

Most common causes of P2162 (most likely first)

Mechanic's Pro Tip

On modern cars, check the ABS module codes first. If one wheel speed sensor has failed, the engine and gearbox often lose the vehicle speed signal too, and replacing the 'speed sensor' on the gearbox will not help.

  1. 1.One of the two sensors is faulty or drifting

    Most likely

  2. 2.Mechanical cause

    For example a stretched timing chain, a wrong installation or a leak that really makes the two values differ.

  3. 3.Wiring fault on one of the two signals

  4. 4.Failed vehicle speed sensor or ABS wheel speed sensor

  5. 5.Damaged reluctor ring or sensor tip contaminated with debris

  6. 6.Instrument cluster or ABS module fault (shared signal)

  7. 7.Wrong tyre size or gearbox coding

    Can make the signal implausible.

Step-by-step diagnostic guide

  1. 1

    Read all modules

    Read codes in the engine, gearbox, ABS and instrument cluster to see where the speed signal is lost.

  2. 2

    Compare both signals side by side

    Display both values together in live data (or on a two-channel oscilloscope) and see which one is out of line with the actual conditions. Fix that signal or the mechanical cause first.

  3. 3

    Compare speed signals

    Compare vehicle speed with the four wheel speeds in live data while driving slowly.

  4. 4

    Inspect sensor and wiring

    Check the sensor connector, the wiring and the sensor tip for debris.

  5. 5

    Measure the sensor

    Check supply and signal on Hall sensors, resistance and AC output on inductive sensors.

    Multimeter: Inductive sensors: often a few hundred ohms to about 2 kΩ and an AC voltage rising with speed.

  6. 6

    Repair and verify

    Replace the faulty sensor or repair wiring, clear codes and confirm a steady speed signal on a test drive.

Frequently asked questions

Can I keep driving with P2162?

Yes, carefully. The speedometer may be wrong or dead and the automatic gearbox may shift harshly – keep an eye on your speed.

How much does it cost to fix P2162?

Typical repair costs are 30 € – 400 €, depending on the cause and the vehicle. The most common fixes are: one of the two sensors is faulty or drifting; mechanical cause; wiring fault on one of the two signals. Always confirm the cause with the tests above before buying parts.

Where is the vehicle speed sensor?

On older cars on the gearbox; on most modern cars the vehicle speed is calculated from the ABS wheel speed sensors.

Can a speed sensor fault affect the gearbox?

Yes. Automatic gearboxes need the speed signal to choose gears, so they may shift harshly or go into limp mode.

What is the difference between P2162 and similar codes?

P2162 belongs to a group of codes for the same component that differ in the type or location of the fault: P0608 – Control Module VSS Output A Malfunction; P0609 – Control Module VSS Output B Malfunction; P2158 – Vehicle Speed Sensor B; P2159 – Vehicle Speed Sensor B Range/Performance; P2160 – Vehicle Speed Sensor B Circuit Low; P2161 – Vehicle Speed Sensor B Intermittent/Erratic. The tests on this page apply to the whole group; the type of fault tells you where to start.

Related fault codes

This guide is for information only. Working on vehicles can be dangerous — if you are unsure, have the car checked by a qualified mechanic. Values can differ between model years; always check the manufacturer's repair information.